Zc Setup - dbx 260 User Manual

DriveRack
To set the PUP Program option use the following procedure:
From Program mode, press the UTILITY button and use the PREV PG or NEXT PG buttons to move to the
•
page that appears as follows:
With the arrow next to the PUP Program option, turn the DATA wheel to make the desired selection.
•
To change the PUP Mute setup, use the following procedure:
From Program mode, press the UTILITY button and use the PREV PG or NEXT PG button to move to the
•
page that appears as follows:
Select the PUP Mute option by pressing the DATA wheel until PUP Mute is selected. Once the PUP Mute option
•
has been selected, proceed to rotate the DATA wheel until the desired mute setting is selected. To exit, press
the PROGRAM/CONFIG button.

5.3 ZC Setup

A unique feature of the DriveRack 260 is its ability to interface with dbx proprietary Zone Controller wall-panels.
This feature gives you the ability to control various parameters of the 260 such as Output Levels, Mute and Program
Changes. Up to six ZC panels can be connected to a DriveRack 260. To program a ZC panel, proceed with the following
instructions.
From Program mode, press the UTILITY button and use the PREV PG or NEXT PG button to move to the
•
page that appears as follows:
Power Up Modes
PUP Program Stored
PUP Mute Current
Important Note: The dip switches on the ZC panel(s) must match the Panel (ID) number displayed in this page.
• If any ZCs are currently connected and their dip switches properly set, the display will read 'Panel Detected' for
any such corresponding Panel (ID) numbers. Rotate the DATA wheel to select the desired Panel (ID) number
(options are 1-6). Once the panel to edit has been selected, press the STORE button. The display will now give
you the option of selecting one of the following by rotating the DATA wheel:
®
Power Up Modes
10 PUP Program Stored
RTA PUP Mute
Power Up Modes
10 PUP Program Stored
RTA PUP Mute
ZC Setup
Panel 1 None
(STORE) - EDIT PANEL
Panel 1
Boost 0dB Cut 0dB
Output
Panel 1
Utilities/Meters
Current
Current
ZC-2
1 3 5
2 4 6
DriveRack® 260 User Manual
ZC-3
Section 5
ZC Setup
Panel 1 None
(STORE) - EDIT PANEL
Panel 1 ZC-2
Boost 0dB Cut 0d
Output
1 3 5
2 4 6
ZC Setup
Panel 1 None
Panel 1 ZC-3
(STORE) - EDIT PANEL
Select A
No Change
Panel 1 ZC-2
Boost 0dB Cut 0d
Panel 1 ZC-4
Output
1 3 5
Switch
1 2
2 4 6
No Change
Panel 1 ZC-3
Select A
No Change
Set Security Level
Pre EQ
Low
Panel 1 ZC-4
Switch
1 2
No Change
39
3 4
3 4