Programmed Scan - Icom IC-7850 Instruction Manual

■ Programmed scan

A Programmed scan searches for signals between
Scan Edge memory channels "P1" and "P2."
Before starting the programmed scan, you must enter
Scan Edge frequencies into these channels.
If the same frequencies are entered into Scan Edge
memory channels P1 and P2, the Programmed
scan does not start.
 The Multi-function screens are OFF.
Push [V/M].
q
• Selects the VFO mode.
• Push [V/M] toggles between the VFO and Memory
modes.
Push a Mode key to select the desired operating
w
mode.
• The operating mode can be changed while scanning.
e Push [TS] to select the desired tuning steps.
• The tuning steps can be changed while scanning.
Push [SCAN](F).
r
• The Scan screen is displayed.
Push [PROG](F).
t
• The Programmed scan starts.
• " " and decimal points blink while scan-
PROGRAM SCAN
ning.
• Push [PROG](F) to cancel the scan.
• Rotating [MAIN DIAL] also cancels the scan.
• Hold down [RECALL](F) for 1 second to recall the fre-
quencies that are set before starting the scan (P1 and
P2), if desired.
When the scan detects a signal, the scan stops,
y
pauses or ignores it, depending on the Scan Re-
sume setting and the squelch status.
(F) Function keys
• While scanning
(p. 4-7)
Blinks
12-5
[V/M]
[EXIT/SET]
Mode keys
Blinks
12
SCANS
[TS]
[MAIN DIAL]