Table Of Contents - Kyocera FS-1050 Installation Manual

Caution
NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION.
Notice on Software
SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION
MODE. The printer is factory-set to emulate the HP PCL 6. The emulation mode can be changed by
following the procedures described in the User's Manual contained as an electronic file in the Kyo-
cera Mita Digital Library CD-ROM supplied with the printer.
Notice
The information in this manual is subject to change without notification. Additional pages may be
inserted in future editions. The user is asked to excuse any technical inaccuracies or typographical
errors in the present edition.
No responsibility is assumed if accidents occur while the user is following the instructions in this
manual. No responsibility is assumed for defects in the printer's firmware (contents of its read-only
memory).
This manual, any copyrightable subject matter sold or provided with or in connection with the sale
of the page printer, are protected by copyright. All rights are reserved. Copying or other reproduc-
tion of all or part of this manual, any copyrightable subject matter without the prior written consent
of Kyocera Corporation is prohibited. Any copies made of all or part of this manual, any copyright-
able subject must contain the same copyright notice as the material from which the copying is done.

Table of Contents

STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
©2001 by KYOCERA CORPORATION. All rights reserved, Revision 1.1., October 2001
Unpacking .......................................................................1
Positioning the Printer....................................................2
Installing the Toner Container........................................3
Connecting the Printer to the Computer .......................6
Connecting the Power Cord...........................................8
Adding Paper to the Paper Cassette and MP Tray........9
Using the Face-Up Output Tray....................................14
Turning the Power Switch On.......................................15
Printing a Status Page..................................................16