Step; Turning The Power Switch On; Please Wait - Kyocera FS-1050 Installation Manual

STEP

Turning the Power Switch On

8
This section describes the procedure for turning on the printer's power.
During start-up, the language for the message display and status page of this printer
can be selected from English, French, German, Italian, Spanish, and Portuguese.
The default message language is English. For how to change the message lan-
guage to another, refer to the Selecting a Message Language section.
Ready
--- A4 PLAIN
Selecting a Message Language
The default message language is English. To change the message language to
another, follow the procedure described below. If required, your dealer can down-
load major languages other than English, French, German, Italian, Spanish, and
Portuguese to your printer. Please contact your dealer.
MENU

Please wait

1
2
1
ENTER
2
Switch on the printer's power. The mes-
sage display should indicate Self
test.
If the indicator does not light,
check that previous steps were
performed properly.
When the printer is first switched
on after installation, there will be a
delay of approximately 15 minutes
before the printer gets ready to
print as the developer unit needs to
be filled with toner. During this
period, the message display shows
Please wait (Adding toner).
Wait until the READY indicator is also
lit and the message display indicates
Ready. The printer is ready to print.
While pressing the ENTER key, turn the
power switch ON ( l ). Keep pressing the
ENTER key until the message display
indicates Please wait (approximately
1 minute). The message display should
indicate Self test.
When the message display shows
Please wait, release the ENTER key.
15