Kyocera FS-1050 Installation Manual page 14

Multi-Purpose (MP) tray
Flap
Correct
Incorrect
12
1
Pull the MP tray towards you until it
stops.
2
Pull out the subtray and unfold the flap.
Subtray
3
Adjust the position of the paper guides
on the MP tray. Standard paper sizes
are attached to the MP tray. For stan-
dard paper sizes, slide the guides to the
position marked correspondingly.
• Do not load more paper than
will fit under the load limits on
the inside of the MP tray.
• If the paper is considerably
curled in one direction, for
example, if the paper is
already printed on one side,
try to roll the paper in the
opposite direction to counter-
act the curl. Printed sheets
will then come out flat.