Options - MULTIQUIP J-36 Operation And Parts Manual

NOTE
Blades are a vital part of finishing concrete. This trowel, or
finisher , has been designed to finish concrete and the blades are
built to stringent quality standards out of the finest trowel steel. If
you need replacement blades, consult your parts list in this
manual for part numbers and order them from your Multiquip parts
dealer or importer.
Combo Blades
This trowel was equipped with combination float/finish (Figure
33) blades as original equipment. These blades have been
designed for optimum performance in both the floating and
finishing operations. These blades are versatile and should take
care of most troweling needs.
Figure 33. Combination Blade
Finish Blades (Optional)
These blades (Figure 34) have been specifically designed for
finish operations with this trowel. They will provide a premium
surface finishing capability from your trowel. They should only be
used after the concrete has set to the point where the trowel does
not sink into the concrete when placed on it.
Figure 34. Finish Blade
J-36/M-30 WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #0 (12/29/06) — PAGE 29
Blades should be changed when
they fail to finish concrete in a
satisfactory manner.
J-36/M-30 TROWEL — OPTIONS
Clip-On Float Blades (Optional)
These blades will clip (Figure 35) on to an existing installed blade,
allowing your finisher to float on "wet" concrete so that the
troweling operation can begin as early as possible. They are
easily removable, so that after the floating operation, when the
concrete is sufficiently cured, they can be removed to expose the
finish blades for continued troweling.
Figure 35. Clip-On Float Blade
Float Discs (Optional)
These round discs (Figure 36) attach to the spiders and allow the
machine to "float" on "wet" concrete. The disc design allows early
floating and easy movement from wet to dry areas. They are also
very effective in embedding large aggregates and surface
hardeners.
Figure 36. Float Disk