Options - MULTIQUIP PRO46 Operation And Parts Manual

NOTICE
Trowel blades should be changed when they fail to finish
concrete in a satisfactory manner.
Blades are a vital part of finishing concrete. This trowel,
or finisher, has been designed to finish concrete and the
blades are built to stringent quality standards out of the
finest steel.
If you need replacement blades, consult the parts list in
this manual for part numbers and order them from your
Multiquip parts dealer or importer.
Combo Blades
This trowel is equipped with combination float/finish
(Figure 49) blades as original equipment. These blades
have been designed for optimum performance in both the
floating and finishing operations. These blades are versatile
and should take care of most troweling needs.
Figure 49. Combination Blade
Finish Blades (Optional)
These blades (Figure 50) have been specifically designed
for finish operations with this trowel. They will provide a
premium surface finishing capability from your trowel.
They should only be used after the concrete has set to
the point where the trowel does not sink into the concrete
when placed on it.
Figure 50. Finish Blade
PRO46 SERIES WALK-BEHIND TROWEL • OPERATION AND PARTS MANUAL — REV. #1 (8/20/15) — PAGE 37
Clip-On Float Blades (Optional)
These blades will clip (Figure 51) onto an existing installed
blade, allowing your finisher to float on "wet" concrete so
that the troweling operation can begin as early as possible.
These blades are easily removable, so that after the floating
operation, when the concrete is sufficiently cured, they
can be removed to expose the finish blades for continued
troweling.
Figure 51. Clip-On Float Blade
Float Discs (Optional)
These round discs (Figure 52) attach to the spiders and
allow the machine to "float" on "wet" concrete. The disc
design allows early floating and easy movement from wet
to dry areas. They are also very effective in embedding
large aggregates and surface hardeners.
Figure 52. Float Disc/Pan

OPTIONS