Assembly And Installation - MULTIQUIP J-36 Operation And Parts Manual

2. Lock the spring in the compressed position, by releasing
the blade pitch adjustment trigger.
3. Remove one brass set nut from the blade pitch cable end
as shown in (Figure 16).
4. Thread the second brass set nut towards the cable as far
as possible.
2
1 Blade Pitch Cable
2 Remove First Brass "Set" Nut
3 Thread Second Brass "Set" Nut
to End of Cable
Figure 16. Blade Pitch Cable
5. Insert the cable end through the yoke eyelet (Figure 17)
Tighten the first brass set nut by hand to remove all the
slack from the cable.
6 Using a wrench, tighten the second brass set nut up against
the yoke boss. This will lock the cable in place.
7. Use a wrench and finish tightening the first brass set nut up
against the yoke boss.
1
2
4
PAGE 22 — J-36/M-30 WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #0 (12/29/06)
J-36/M-30 TROWEL — ASSEMBLY AND INSTALLATION
1
3
3
1 Yoke
2 Thread Cable End Through Yoke Eyelet
3 Use a Wrench to Tighten First Brass Set
Nut Against Yoke Boss
4 Tighten Second Brass Set Nut Against
Yoke Boss
Figure 17. Cable Yoke Attachment
Pre-load Adjustment
1. After the Quick-Pitch™ handle has been installed on the
trowel, spring pre-load adjustment will be required.
2. Locate the adjustment screw on the underside of the handle
tube (Figure 18).
1
PRELOAD TRIM INDICATOR
J
FINISH FINISH
COMBO
1 Alignment Decal
2 Align This Arrow With The Letter "J"
Combo On Decal
3 Adjustment Screw
Figure 18. Pre-load Adjustment
3. A decal has been placed on the side of the handle tube to
assist the user in the adjustment of the spring.
4. Align the arrow on the adjustment screw with the letter "J"
COMBO on the decal . The letter "J" stands for J-36/M-30
Walk-Behind trowel.
5. Test the pitch control operation and adjust if necessary.
B
COMBO
2
3