Options - MULTIQUIP HPHA36C5H Operation And Parts Manual

Blades
NOTE
Blades are a vital part of finishing concrete. This trowel, or
finisher , has been designed to finish concrete and the blades are
built to stringent quality standards out of the finest trowel steel. If
you need replacement blades, consult your parts list for part
numbers and order them from your Multiquip parts dealer or
importer.
Combo Blades
This trowel was equipped with combination float/finish (Figure
31) blades as original equipment. These blades have been
designed for optimum performance in both the floating and
finishing operations. These blades are versatile and should take
care of most troweling needs.
Figure 31. Combination Blade
Finish Blades (Optional)
These blades (Figure 32) have been specifically designed for
finish operations with this trowel. They will provide a premium
surface finishing capability from your trowel. They should only be
used after the concrete has set to the point where the trowel does
not sink into the concrete when placed on it.
Figure 32. Finish Blade
PAGE 28 — HPHA36C5H WALK-BEHIND TROWEL— OPERATION AND PARTS MANUAL — REV. #3 (07/06/10 )
Blades should be changed when
they fail to finish concrete in a
satisfactory manner.
HPHA36C5H TROWEL — OPTIONS
Clip-On Float Blades (Optional)
These blades will clip (Figure 33) on to an existing installed blade,
allowing your finisher to float on "wet" concrete so that the
troweling operation can begin as early as possible. They are
easily removable, so that after the floating operation, when the
concrete is sufficiently cured, they can be removed to expose the
finish blades for continued troweling.
Figure 33. Clip-On Float Blade
Float Discs (Optional)
These round discs (Figure 34) attach to the spiders and allow the
machine to "float" on "wet" concrete. The disc design allows early
floating and easy movement from wet to dry areas. They are also
very effective in embedding large aggregates and surface
hardeners.
Figure 34. Float Disk