Cone Board Setting In The Processor Unit - Furuno FSV-24 Installation Manual

3.5

CONE Board Setting in the Processor Unit

Adjust the potentiometers on the CONE Board in the processor unit, referring to
the table shown below.
Location No. Name
R118 ALARM
R119 ES2_OFF
R167 ES_2GAIN
R168 ES1_OFF
R209 ES1_GAIN
3.5.1 Adjustment of signal level (echo sounder connected)
Adjusts the output level of the echo sounder on the CONE Board as below.
1. Select an echo sounder display (ES1 or ES2) from the menu.
2. For ES 1, adjust R168 to suppress noise, and then adjust R209 so that the
picture condition is similar to that of connected echo sounder connected to
the FSV-24.
3. For E/S 2, adjust R119 to suppress noise, and then adjust R167 so that the
picture condition is similar to that of echo sounder connected to the FSV-24.
3.5.2 Adjusting the volume of audio alarm
The audio alarm volume cannot be adjusted from the control unit. If necessary,
adjust R118 on the CONE Board to choose desired volume.
3-12
Resistance value Function
10 kΩ Adjusting the volume of
audio alarm.
1 kΩ Adjusting E/S2 signal
offset.
10 kΩ Adjusting E/S2 signal gain.
1 kΩ Adjust E/S1 signal offset.
10 kΩ Adjust E/S1 signal gain.
Adjustment
CW: Large
CCW: Small
CW: Noise decrease
CCW: Noise increase
CW: Gain increase
CCW: Gain decrease
CW: Noise decrease
CCW: Noise increase
CW: Gain increase
CCW: Gain decrease