Table of Contents
Advertisement
2.
WIRING
2.1
How to Use the Crimping Tool, Pin Extractor
A special crimping tool is necessary for connection of wires to the contact pins of
the 38P connector. The pin extractor removes the contact pin from the connector
body. This paragraph describes how to crimp and extract the contact pin.
2.1.1
How to use the crimping tool
1. Strip the vinyl sheath of the wire to
expose the core by 3 mm to 4 mm.
2. Hold the crimping tool horizontally and
insert the contact pin with its slit facing
downward into the crimp hole on the
crimping tool.
3. Insert the wire onto the contact pin and
squeeze the handle until the rachet
releases. (The wire should be placed
deep enough into the contact pin so
that its end comes in contact with the
stopper plate of the crimping tool.) With
crimping completed, pull the wire while
holding the contact pin to make sure
that it is tightly fastened.
2.1.2
How to use the pin extractor
If a contact pin is inserted into an incorrect
hole on the connector body, remove it with
the pin extractor.
1. Push the pin extractor into the pin hole
from the side opposite to the pin
inserting side.
2. Push in the head of the pin extractor. The retaining spring comes free and the
contact pin can be removed.
Crimping Tool
06-1001-016
Crimping tool, contact pin, pin extractor
Contact Pin
60-8017-0313-00-339
(000-519-542)
2
Pin Extractor
06-1877-04
(000-519-595)
1
2-1
Advertisement
Table of Contents
