Table of Contents
Advertisement
Preparatory installation
of roof hooks
Fitting roof hooks to battens
(installed before)
Fitting roof hooks to rafters
(refit)
Joining the mounting rails
12
Rooftop installation - General
Top roof hooks
M8 x 20
coach bolt
M8 x 20
coach bolt
Top roof hooks
Initially tighten the roof hooks only by hand.
Note:
Some tile shapes (e.g. flat tiles that are profiled at the top and bottom) must
be cut out in the area of the roof hooks to enable the fitted roof hooks to lie
correctly and to prevent the tile above from lifting up.
Recommendation:
We recommend the use of metal tiles below the roof hooks, particularly in
areas of high snowfall.
The mounting rails can be extended by using mounting rail joiners.
One of the 3 screws of the mounting rail joiner set can also be used for securing
to a roof hook. For this, the U-rail remains centrally aligned; the screw can be
manoeuvred within the slot to the correct position above the hook.
Mounting rail for
2 collectors, e.g.
Short bracket
on top
M8 washer nut
M8 x 20
coach bolt
Long bracket
on top
Mounting rail
joining set
3 M8 x 25 coach bolts with M8 washer nuts
Bottom roof hooks
M8 washer nut
Bottom roof hooks
Mounting rail for one
additional collector, e.g.
3062815_201508
>15°
Advertisement
Table of Contents
