Sharp FO-1660 Service Manual page 7

3
Take the new film out of its package, and insert two of the gears
provided with the fax into the ends of the spool with film. Make
sure that the two tabs on the gears fit properly into the slots in the
ends of the spool.
•
Do not yet remove the band which holds the spools together.
2 tabs
4
Hold the empty spool so that the end with only one slot is on the
left, and lower the spools into the front of the printing compart-
ment. The gears in the ends of the spool with film should fit into
the slots on each side of the printing compartment.
5
Cut the band which holds the spools together with scissors, and
remove it. Insert the remaining gear into the right end of the empty
spool and the flange into the left end of the empty spool. Make
sure the tabs on the gear and the flange fit into the slots in the
ends of the spool (the gear has two tabs and the flange has one
tab).
1 tab
Flange
6
Pull the empty spool toward the back of the compartment, unwind-
ing the film as you pull.
7
8
9
2 tabs
Gear
F
1 – 5
Insert the empty spool into the back of the compartment so that
the gear and the flange fit into the slots on the sides of the
compartment.
•
Make sure that the gear engages with the gear below it.
Wind the film slightly (rotate the gear on the right side of the
empty spool) so that there is no slack in the film. Make sure that
both edges of the film wind onto the spool evenly.
Close the print compartment cover, making sure it clicks into
place.
•
Caution! Close the cover slowly to make sure it doesn't pinch
your fingers.
If you replaced the film, initialize the new film by pressing the
FUNCTION key, the "6" key, and the "#" key on the operation
panel. Make sure that INITIALIZE FILM appears in the display,
and then press the START key. (Do not perform this step if you
installed the initial sample roll of film.)
FUNCTION
START
UX-600MU/MC
FO-1660U/C
6