Sharp FO-1660 Service Manual page 13

Loading paper
1. Insert the paper tray into the fax if
not yet installed.
2. Remove the paper cover if it is
on the tray. (For legal paper, flip
up the tray externder.)
3. Pull the paper release plate to-
ward you.
If any paper remains in the tray,
take it out and combine it into a
single stack with the new paper.
4. Insert the stack of paper into the
tray. Replace the tray cover and
then push the paper release plate
back down.
5. Press the following sequence of
keys:
Press "1" if you loaded letter size
paper, or "2" if you loaded legal
FUNCTION
6
size paper.
STOP
When finished, press:
LEGAL
LETTER
Installing the imaging film
1. Press the release marked OPEN
and open the print compartment
cover.
2. Insert two of the gears into the
ends of the spool with film.
3. Hold the empty spool so that the
end with only one slot is on the
left, and lower the spools into the
printing compartment so that the
gears fit into the slots on each
side of the compartment.
4. Cut the band holding the spools
together with scissors, and re-
move it. Insert the remaining gear
into the right end of the empty
spool and the flange into the left
end of the empty spool.
5. Pull the empty spool toward the
back of the compartment, un-
winding the leader from the spool
with film. Insert the empty spool
into the compartment so that gear
and spool fit into the slots on
each side of the compartment.
6. Wind the film slightly to remove
slack and then close the printer
compartment cover.
7. If you replaced the film. press the
following sequence of keys (this
is not necessary for the sample
film included with the fax):
FUNCTION
6
1 – 11
UX-600MU/MC
FO-1660U/C
START