Table of Contents
Advertisement
2
Press CHARACTER.
The text input screen appears, and the cursor
flashes.
3
Press CHARACTER to select the
desired type of character.
Each time you press the button, the display
changes as follows:
A (Upper cases) t a (Lower cases) t 0
(Numbers) t ! (Symbols) t (Blank
space) t A (Upper cases) t ...
4
Press . or > repeatedly to select
the desired character.
To enter a blank space
Press CURSORt without pressing . or
>. You cannot enter a space as the first
character.
To enter a symbol
You can use the following 24 symbols.
! " # $ % & ' ( )
5
Press CURSORt .
The character you selected in step 4 stops
flashing and the cursor shifts to the right.
Cursor
+ , – . / : ; < = > ? @ _ `
Cursor
6
Repeat steps 3 to 5 to complete the
entire title.
If you made a mistake
Press CURSORT or t until the character
you want to change flashes, then repeat steps
3 to 5.
To erase a character
Press CLEAR while the character is flashing.
You cannot insert characters.
7
Press ENTER/YES to complete the
labelling procedure.
The disc title is stored in the system memory
and then the original display appears.
To cancel labelling
Press MENU/NO.
Tip
In step 3 you can enter a space directly by pressing
SPACE without selecting
Checking the disc titles
1 Press MENU/NO in stop mode.
2 Press . or > repeatedly until "Name
Check ?" appears, then press ENTER/YES.
3 Press . or > repeatedly to select the disc
titles stored in the system memory between 001
and 050.
To check the current disc title
Press SCROLL in stop mode.
(blank space).
continued
19
Advertisement
Table of Contents
