Disassembly And Assembly - JUKI 6100 Technical Manual

5.2
Disassembly and assembly
The
following describes the disassembly procedures
for the
main
parts
of the
printer.
Unless otherwise described, assemble the parts
in
reverse order
from
disassembly procedures.
CAUTION:
BEFORE PROCEEDING WITH
ANY
OF THE REMOVAL/
REPLACEMENT PROCEDURES YOU SHOULD TURN THE
PRINTER
OFF
DISCONNECT THE
POWER CORD AND
UNPLUG THE
INTERFACE CONNECTOR.
NOTE:
All
procedures outlined
in
the removal/replacement section of this
manual assume
that the tractor
assembly
is
not
present
on your
printer.
For
tractor
removal
see
your
tractor
installation
manual.
5.2.1
Removing the covers (Refer to
Fig. 5.1
on
Page 10
and
Page
13)
(
1 )
Top
cover
and
acoustic cover
assembly
(T)
To
remove
the
top cover
and acoustic cover
assembly simply
pull
up
along
the front
edge
until
it
disengages
from the center cover assembly.
Once
the
front
edge
is
free,
pull
up
along the
front edge
until
it
disengages
from
the
center cover assembly.
Once
the front
edge
is
free, pull
the top cover
toward
you
to
completely
remove
it.
(2)
Removing
the center cover
(2)
Step
1.
Move
the carriage to
the center
of
the platen.
Step
2.
Move
the
paper
guide
to the
far left
and
then turn
the
paper
table
toward the rear of the machine.
Step
3.
Pull the
paper
release lever
to the
forward
(released) position.
Step
4.
To
remove
the platen
assembly, locate the
two
black
plastic
platen
bearings.
On
each bearing there are
two
protrusions.
Pinch the
two
protrusions together while gently pulling the platen
away from
the
frame.
Repeat
this
procedure for
both ends of
the platen.
Step
5.
Remove
two
screws
(§)
which
are
located
just
below
the area
where the platen
knobs
exit the cover.
Step
6.
There
are
5
points
(
)
along the front
edge of the center
cover
which must be disengaged
from
the
bottom
cover.
Reach
points designated to
detach the
five clasps.
Step
7.
Slowly
lift
the front of the center cover
and push toward
the rear
to disengage the
last
3 clasps. Lift
the cover
away from
the printer
assembly.
(3)
Removing
the
bottom
cover
(4)
Step
1
.
Move
the
carriage as far
to the
left
as possible.
Step
2.
Locate
two
ribbon cable assemblies,
1
center
and
1
far right in
the
base of the printer.
Remove and
retain
two
pieces of tape
from
each of the
ribbon cable assemblies.
-
9
-