System Error: 010039; System Error: 010040; System Error: 010041 - HP DesignJet 2500CP Service Manual

System Error:
Problem Description: A Printhead voltage could not be set Carriage
Corrective Action:
System Error:
Problem Description: The Ambient Temperature measured is out of the
Corrective Action:
System Error:
Problem Description: Problem in setting the Printhead Voltage.
Corrective Action:
System Error Codes
010039
PCA Failure
Try the following:
D Make sure that the Trailing Cable is connected
correctly.
D Replace the Trailing Cable ' page 8 36.
D Replace the Carriage Assembly ' page 8 42.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
010040
normal range.
Try the following:
D Make sure that the Trailing Cable is connected
correctly.
D Replace the Trailing Cable ' page 8 36.
D Replace the Carriage Assembly ' page 8 42.
D Replace the Electronics Module ' page 8 6.
Only replace one component at a time and
check if the error has gone before replacing
another component. Using this procedure
you will be able to determine exactly which
component failed.
010041
Switch the Printer OFF and ON again. During
initialization another error code will appear. Refer
to the relevant error code for further information.
HP DesignJet CP Series Printers 2-13