System Setup - HP 54 Basic Cutter User Manual

There are five typical FlexCut parameters:
Full pressure: This parameter determines full pressure, used during FlexCut mode.
●
Full pressure cut length: This parameter determines the length that is cut with full pressure, usually the
●
length that will be cut all the way through.
Flex pressure cut length: This parameter determines the length that will be cut with reduced pressure or
●
without pressure. This is usually a much smaller value than the full pressure cut length: the length of the
substrate bridges.
FlexCut pressure: This parameter determines the pressure of the Flex pressure cut length. This is usually a
●
reduced pressure, so that the knife only scratches the substrate or cuts it only halfway through.
FlexCut velocity: FlexCut uses higher knife pressures. Higher knife pressures need lower cutting speed. With
●
this parameter the velocity of FlexCut can be set independently from the normal cutting velocity.
See Cut through on page 30
Tool
How to change tools is explained in

System setup

Press to access the remaining parameters and internal tests.
Actions
Confidence test
The confidence test performs a quick electrical and mechanical test of the cutter to make sure it is fully
operational. A sheet of substrate of at least A3/B size should be used for this test. The sheet is always cut on the
left side. Press
Load
This menu can be used when loading a substrate sheet. During loading, the maximum substrate length can be
set.
Extended load
This parameter is explained in
Reset
The Reset instruction performs a complete reset of the cutter. Press
ENWW
for more details.
Set the tool type on page
to start the test.
Extended load on page
50.
27.
to execute a reset.
System setup 35