HP DesignJet 2500CP Service Manual page 118

Calibrations
The Printer has several calibration procedures that must be performed under
certain conditions. Refer to the table below to determine when calibrations
are required.
REMEMBER THAT CERTAIN CALIBRATIONS ARE REQUIRED
EVEN IF AN ASSEMBLY HAS BEEN DISASSEMBLED TO GAIN
ACCESS TO ANOTHER ASSEMBLY OR COMPONENT.
When Required
Electronics Module is
replaced
Carriage is disassembled or
replaced
Refill Assembly is
disassembled or replaced
X axis Assembly is
disassembled or replaced
Drive Roller is disassembled
or replaced
Banding Problem
Edge Detect Problem
Misalignment between
Colors
Color Accuracy Problem
Nozzles Out or Misdirected
5-2
Calibrations To Be Done
C01 C02 C03 C05
Yes Yes Yes Yes
Yes Yes Yes Yes
No Yes No Yes
No No No No
No No No No
No No Yes Yes
No No Yes No
No No Yes Yes
No No Yes No
No No No No
HP DesignJet CP Series Printers
C06 C07 C08 C09
Yes Yes Yes Yes
Yes Yes Yes No
No Yes No No
No No Yes No
No No Yes No
Yes No Yes No
No No No No
Yes No Yes No
No Yes No No
Yes No No No
Service Calibrations
C10
Yes
No
No
No
No
No
No
No
No
No