HP DesignJet 2500CP Service Manual page 220

3. X encoder cable in J1
4. Service station cable in J11
5. Refill station cable in J4
6. Media sensor cable in J6
7. Pinch wheel sensor cable in J8
8. X motor cable in J7
9. Trailing cable in J3, J5 and J10
Install the left and right hand back covers (items 7 and 8).
7.
Connect the power cord and turn the printer on in service mode.
8.
If a new electronics module is being installed, perform the following
9.
service calibrations:
1. C01 Carriage ' page 5 6
2. C02 Refill ' page 5 8
3. C03 Line Sensor ' page 5 9
4. C10 Font Type Set ' page 5 19
5. C05 Printheads Alignment ' page 5 12
6. C06 Printheads Check ' page 5 13
7. C07 Color Calibration Only for HP DesignJet 2500CP/3500CP
printer ' page 5 15
8. C08 Service Accuracy ' page 5 16
9. C09 Maintenance ' page 5 18 (Adjust Counter)
10. C10 Font Type Set ' page 5 19 (Only for Asian Fonts)
Perform the D01 Electronics service test ' page 4 6.
10.
8-8 HP DesignJet CP Series Printers Removal and Installation