Removing An Internal Hard Disk Drive - NEC Express5800 User Manual

18. Install the cable protector as described earlier in this chapter.
19. Upright the server.
20. Install the left side panel as described earlier in this chapter and power on
the server.

Removing an Internal Hard Disk Drive

1. Power off the system and remove the left side panel as described earlier in
this chapter.
Observe static precautions. Use an antistatic wrist strap.
2. Tilt the server on its side.
3. Remove the cable protector as described earlier in this chapter.
4. Remove all the cables connected to any installed hard disk.
Pull out cables slowly and carefully. Note that your hand
may not hit on some surrounding components in the
disconnection. If so, the components may be damaged. If
the power cable is hard to disconnect, first remove the hard
disk.
5. Lift the lock lever on the fan installed in the hard disk bracket lightly to
release the lock. See Figure 4-18.
6. Slide the fan with the lock released towards the top of the server to remove
the fan. See Figure 4-19.
Do not place the removed fan on the system board. If you
place the removed fan on the system board, some
components on the system board may be damaged.
6. Remove four screws securing the hard disk drive cage to the system chassis.
See Figure 4-20.
7. Slide the hard disk bracket as shown in Figure 4-21 to remove the hard disk
bracket from the bracket for the floppy disk drive.
8. Remove the four screws securing the disk drive to the drive cage.
9. Slide the hard disk drive out of the drive cage.
10. Remove the drive model and serial number from the equipment log.
! CAUTION
! CAUTION
! CAUTION
Upgrading Your System 4-25