Installing Microsoft Windows 2000 Operating System - NEC Express5800 User Manual

Installing Microsoft Windows
Use the following procedure to set up and perform a clean Windows 2000 Operating
System installation on your server.
1. Insert the Windows 2000 CD into the CD-ROM drive and boot your system by
pressing CTRL+ALT+Delete.
Note
installed in your server; go to Step 7 if your server does not include a
RAID or SCSI controller.
2. While the message "Setup is inspecting your computer's hardware configuration" or
a solid blue background is displayed on the screen, press the F6 key.
Note
key has been pressed.
3. When the following message is displayed, press S.
"Setup could not determine the type of one or more mass storage devices installed
in your system, or you have chosen to manually specify an adapter". Currently,
Setup will load support for the following mass storage devices.
4. When the following message is displayed, select "Other" and then press Enter.
Select the SCSI Adapter your want from the following list, or select "Other" if you
have a device support disk provided by an adapter manufacturer
5. Insert the "Windows 2000 OEM-DISK" diskette into the floppy drive, and press
Enter. A list of mass storage devices is displayed.
6. Select the SCSI or RAID disk array controller installed in your server from the list
of mass storage devices.
7. Follow the messages on the screen to continue to install.
Note
Guide for more extensive installation procedures.
For LAN adapter driver installation, see Installing LAN Adapter
Drivers later in this appendix.
8. After installing Windows 2000, logon to the system using the administrator account
or other account, which is a member of the Administrator's group.
®
2000 Operating System
: Perform Steps 2 through 6 if a RAID or SCSI controller is
: There is no visible indication on the screen when the F6
: Please consult the Microsoft Windows 2000 Installation
Installing and Configuring Windows 2000 and Windows NT 4.0 C-5