NEC Express5800 User Manual page 84

4. Set any drive jumpers or switches before you install the drive. See the
documentation that comes with the device for jumper or switch information.
Note:
them. Remove any rails already attached.
5. Slide the drive into the bay until the screw holes line up. Align the front
cover of the installed device with the CDROM drive. It may be necessary to
temporarily loosen the mounting screws on already installed drives to
position the new drive. Secure the drive to the bay with the four supplied
screws. See Figure 4-33.
Power Cable
Figure 4-33. Installing a Removable Media Device
6. Connect the signal and power cables to the device as shown in Figure 4-33.
7. Replace the front panel and side panels, and power on the system.
4-30 Upgrading Your System
If the drive comes with drive rails, do not use
5.25" Drive