Setting The Clock And Delay Brew Time; To Set The Clock; To Set The Delay Brew Time - Oster 3308 Instruction Manual

SETTING THE CLOCK AND DELAY BREW TIME

To Set the Clock:

1. Plug the power cord into a standard electrical outlet. The clock will flash on the control
panel to indicate that the time has not been set yet.
2. Press and hold the hour (HORA) and minute (MIN.) buttons until you reach the current
time. The AM or PM indicator will light at the bottom of the display (Figures 1 and 2).
9
The clock is now set!
NOTE: Pressing any button before setting the clock will cause the clock to start keeping
time from 12:00 a.m. You must set the clock if you want to use the Delay Brew feature.

To Set the Delay Brew Time:

While the display is in the clock mode, simply press the Set Delay (PROGRAMAR) button
(Figure 3) and, while the Delay Brew (COLADO PROG.) yellow light is flashing set the
brew time by pressing the hour (HORA) and minute (MIN.) buttons (Figure 4). The AM or
PM indicator will light at the bottom of the clock display. Within a few seconds the display
will change to the current time.
9
The Delay Brew Time is now set!
NOTE: To activate the Delay Brew (COLADO PROG.) cycle, see the Brewing Coffee
Later section (p. 8). To check the programmed time, push the Set Delay (PROGRAMAR)
button. The display will show the time you have programmed the coffee to brew. If you
press the Set Delay (PROGRAMAR) button again or wait a few seconds, the display will
switch back.
C ol ad o
Pr og .
C ol ar
AM
6
Figure 1
Max
10
C ol ad o
Pr og .
C ol ar
AM
6
Figure 3
Max
10
9
AM
6
Figure 2
8
6
4
2
9
AM
6
Figure 4
8
6
4
2
E ng lis h-5
C ol ad o
Pr og .
C ol ar
Max
10
8
6
4
2
C ol ad o
Pr og .
C ol ar
Max
10
8
6
4
2