Log Placement - Napoleon B35NTE Installation And Operating Instructions Manual

40
6.3

LOG PLACEMENT

EN
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
TM
PHAZER logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing
effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
A. Place the rear log (W135-0543) fi rmly onto
the two studs located at the rear of the
support tray. Ensure the log sits fl at and
does not cover the pilot opening. Place
two pins in holes located on the top of the
rear log.
C. Place the right log (W135-0545) onto the two
studs located on the right side of the log
support.
W415-1399 / B / 06.17.16
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
PINS
A
A
C
B
WARNING
!
PIN
B. Place the left log (W135-0544) onto the two
studs located on the left side of the log support.
D. Place the left crossover log (W135-0546) onto
the pin located in the left side of the rear log,
allow it to rest in the notch of the left log.
76.1A
A
B
D
A
C
B