Front Hood Installation - Napoleon B35NTE Installation And Operating Instructions Manual

Leave a hand on the glass door during entire door
removal. The glass door is secured to the fi rebox with
two spring latches along the top and two along the
bottom. Pull the handles of the latches forward, then lift
the latches out from the door frame to release the top
of the door. Repeat the same step for the two bottom
latches. Next, pivot the door forward until the top
edge clears the front of the appliance. Carefully grip
the sides of the door lifting it off the appliance. NOTE:
These spring latches make up the spring relief
system for the appliance. Ensure they open freely
and close sealed.
Reverse these steps to reinstall the safety screen and
door. Ensure safety screen is installed correctly.
6.2

FRONT HOOD INSTALLATION

NOTE: This hood MUST be installed, if it has not already been factory installed.
A. Safety door and screen must be removed.
B.
Remove the securing screws from the top of the fi rebox, as shown.
C. Install the front hood, ensure it is angled downward when installed.
D. Reinstall the previously removed securing screws.
HOOD
SIDE VIEW
Spring
Latches
39
EN
X5
W415-1399 / B / 06.17.16