For Models With Slideout; To Install Door - Jayco Eagle Owner's Manual

NOTE: Road dirt and grime will sometimes make jacks difficult to operate. You may
need to clean out before operating. To maintain stabilizer jacks keep clean and lubricate
twice a year using only silicone lubricants as oils will attract dirt and cause additional
problems.
Do not place excessive weight on these jacks as they are intended to stabilize, not support
the camper. The camper should be level.
6. Before pulling out front bed, place flat end of bed support brace into slot provided
on frame. Place bent hook into bracket attached to the front wall. (Fig. 3-7)
7. Pull end bunk beds out until rail hits bed stop. Distribute awning panel over bunk
and place corners of tent over corner of bed. Again, be sure beds are now extended
all the way out against stops.
8. Place flattened end of straight bed support pole into slot provided on frame of
camper. Place angled and smashed end of straight bed support pole into bed bracket
near outer corner under plywood bunk bed. (Fig. 3-7)
WARNING: Do not use bed bow support poles if bent or damaged. Replace
all damaged support poles.
9. Now, complete raising roof until gray limit cable is snug. DO NOT OVER-
TIGHTEN. (Fig 3-4)

FOR MODELS WITH SLIDEOUT

a. Unlock Slideout. (Fig. 3-5) Lock is located on the outside of the folding camping
trailer.
b. Pull out slideout using the handle(s) located on the side of the slideout.
CAUTION: Do not extend slideout before pulling beds out.
NOTE: The slideout rollers may leave slight indentations on the linoleum floor.
c. Lock slideout.
d. Pull bed flaps located on the side of the slideout out over edge and attach to Velcro.
e. Enter unit and set up kitchen flip-top. Attach stove grate.
10. Inside unit, for the bed and slideout tent set up, insert bed bow support pole at bow
peg. Push bow outward and upward while pressing on button farthest from the end
and slip into bracket mounted on roof. Release button. (Fig. 3-6)

TO INSTALL DOOR

11. Unlatch twist locks holding door to roof. Swing down the double hinged, self-
storing screen door. Drop channel of lower edge of screen door over entrance door,
guiding locating pins into door jamb extrusion. If door does not align properly,
check jacks to make sure they are adjusted correctly and check camper for levelness.
12. Insert canvas by folding the hard edge of tent over 180º and inserting this portion
into channel of screen door, starting at the bottom. This assures the best possible fit.
13. On units without slideout, set up kitchen flip top and attach grate.
14. Exit unit and pull bed flaps over corners of bed until flaps are extended under the
bed. Securely attach Velcro.
1 8