Ignition - Lp Gas Operation; Start Up - Ac Operation; Start Up - Dc Operation (3-Way Models Only); Shut Down - Jayco Eagle Owner's Manual

When the outside air temperature is less than 50° F, the refrigerator may have a tendency
to freeze food at the colder temperature settings. To reduce the tendency to freeze food:
• Turn the thermostat to a warmer temperature setting.
• Keep the refrigerator full.
• Put foods that are more likely to freeze on the upper shelf.
The selector switch (2) changes the energy source of the refrigerator between LP gas, AC
electric, and DC electric and shuts down the refrigerator at the OFF position.
The gas safety valve (3) is built into the control panel. As long as a flame is present, the
valve is open and allows LP gas to flow into the burner. Any loss of flame (empty LP gas
tank, blow out, etc.) closes and stops the flow of LP gas.
The igniter (4) makes a spark which ignites the flame in the burner.
IGNITION – LP GAS OPERATION
1. Open the valve at the LP gas storage tank.
2. Turn the thermostat to the coldest temperature setting.
3. Turn the selector switch to the LP gas position.
4. Push and hold in the safety valve (see WARNING below) and in rapid succession,
push in the igniter several times for about five seconds.
• Open the burner box door and look for the flame.
• When the flame ignites, release the safety valve.
• If the flame does not ignite, wait about five minutes and do this step again.
WARNING: Do not hold in the safety valve for more than 30 seconds. If
there is no flame in this time, wait at least two minutes before you try ignition
again. If you continue to hold in the safety valve, gas will collect and result in
dangerous personal injury or death.
5. Turn the thermostat to the temperature setting that you wish.
START UP – AC OPERATION
• Make sure that 120-volts AC is available.
• Turn the selector switch to the AC position.
• Turn the thermostat to the temperature setting that you wish.
START UP – DC OPERATION (3-WAY MODELS ONLY)
• Make sure that 12-volts DC is available.
• Turn the selector switch to the DC position.
• Turn the thermostat to the temperature setting that you wish.

SHUT DOWN

• Turn the selector switch to the OFF position.
• Turn the thermostat to the 1 position.
5 1