For Models With Slideout; To Install Door - Jayco Eagle Owner's Manual

NOTE: Road dirt and grime will sometimes make jacks difficult to operate. You may
need to clean out before operating. To maintain stabilizer jacks keep clean
and lubricate twice a year using only silicone lubricants as oils will attract
dirt and cause additional problems.
Do not place excessive weight on these jacks as they are intended to
stabilize, not support the camper. The camper should be level.
NOTE: The bed braces and bed bow braces are stored under the bed mattress. (Fig. 3-7)
CAUTION: For slideout models, pull the slideout tent outside of the unit BEFORE
pulling the beds out. Make sure that all tent material is clear from the bed slide.
6. Before pulling out front bed, place flat end of bed brace into slot provided on frame.
Place bent hook into bracket attached to the front wall. (Fig. 3-8)
7. Pull beds out until rail hits bed stop. Distribute awning panel over bunk and place
corners of tent over corner of bed. Again, be sure beds are now extended all the way
out against stops.
WARNING: Do not use bed braces if they are bent or damaged. Replace all
damaged braces.
8. Place flattened end of straight bed brace into slot provided on frame of camper.
Place angled and smashed end of straight bed brace into bed bracket near outer
corner under plywood bunk bed. (Fig. 3-8)
9. Now, complete raising roof until gray limit cable is almost tight and the tent is
almost taut. DO NOT OVERTIGHTEN. (Fig 3-4)
CAUTION: If the limit cable is raised too high, lifter system/tent damage could
occur and the door will not fit properly.

FOR MODELS WITH SLIDEOUT

a. Unlock Slideout. (Fig. 3-5) Lock is located on the outside of the folding camping
trailer. (Model #14SO does not have a lock.)
b. Pull out slideout using the handle(s) located on the side of the slideout.
CAUTION: Do not extend slideout before pulling beds out.
c. Lock slideout.
d. Pull tent flaps located on the side of the slideout out over edge and attach to Velcro.
e. Enter unit and set up kitchen flip-top. Attach stove grate.
10. Inside unit, for the bed and slideout tent set up, insert bed bow brace at the bed bow
connector. Push bed bow outward and upward while pressing on button farthest
from the end and slip into bracket mounted on roof. Release button. (Fig. 3-6)

TO INSTALL DOOR

11. Unlatch twist locks holding door to roof. Swing down the double hinged, self-
storing screen door. Drop channel of lower edge of screen door over entrance
door, guiding locating pins into door jamb extrusion. If door does not align
properly, check jacks to make sure they are adjusted correctly and check camper
for levelness.
22