To Turn Off Gas To Furnace; Water Heater (Optional); Operation - Jayco Eagle Owner's Manual

To Turn Off Gas to Furnace

1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be performed.
3. Open the access panel to turn OFF electric switch or curcuit breaker.
4. Close the control access panel.

WATER HEATER (Optional)

The water heater is optional as part of the deluxe plumbing and shower package.
Heater operates on LP gas only and will need to be lit manually. Operating instructions
are on the following pages and additional instructions will be found in the manual
supplied by manufacturer.

Operation

Pilot Models – G6A-7; GH6-7; G4-7; GC6A-7; and G6A-7P
CAUTION: Do not tamper with the pilot orifice. High water temperature and
failure of the gas control can result.
1. Turn lighting control to "OFF" position.
2. Wait at least five minutes to allow gas which may have accumulated in burner
compartment to escape.
3. Note that your water heater may have either a Robertshaw "Unitrol" or "White
Rodgers" control.
ROBERTSHAW "UNITROL"
1. Turn lighting control dial to "PILOT" position.
2. Depress and hold reset push button while lighting
pilot burner.
3. Allow pilot to burn for one half minute before
releasing button.
4. Turn control dial to "ON" position.
5. If pilot does not remain lit, repeat operation allow-
ing longer period before releasing push button.
6. Set the dial at the mid-point position between warm and hot.
7. Close access door.
"WHITE RODGERS" CONTROL
1. Turn lighting control dial to "PILOT" posi-
tion and hold against stop while lighting pilot
burner.
2. Allow pilot to burn approximately one half
minute before releasing dial.
3. Turn control knob to "ON" position.
4. If pilot does not remain lit, repeat operation
allowing longer period before releasing button or knob.
Robertshaw "Unitrol"
"White Rodgers" Control
4 8