Shower System; Winterizing Camping Trailer; Non-Power Supply Systems; Demand Or Power Plumbing Systems - Jayco Eagle Owner's Manual

Folding camping trailer
Hide thumbs Also See for Eagle:
Table of Contents

Advertisement

Shower System

The shower system in the folding camping trailer is designed to provide an easy and
convenient method of showering while in the privacy of your personal camper.
To operate the shower facility, observe the following steps:
1. Open shower countertop and secure lock.
2. Install shower hose and head. Observe 2 brackets to mount shower head, first
bracket beside faucet is for travel and storage, second bracket mounted on the roof
to use when taking a shower.
3. Prepare your curtains, shower and privacy to prevent water from reaching areas
other than shower pan.
4. Ensure water heater is in operation.
5. Open faucets and adjust to desired temperature.
6. All used water will drain in gray water tank located below camper floor.
7. To drain gray holding tank, attach a 1¼ x ¾" swivel adaptor and hose to termination
valve. After attachments are secured and hose placed in proper approved facility,
open valve and drain tank. Rinse gray water tank as desired with fresh water.
NOTE:
The water heater has a six gallon capacity. The holding tank has a ten gallon
capacity.
CAUTION: In units with the bath/shower option, ensure the shower head is
secured in the wall holder before closing your camper for moving or storage. If the
shower head is left in the ceiling holder when the camper is closed, damage can
result.

Winterizing Camping Trailer

NON-POWER SUPPLY SYSTEMS

1. Drain tank. The remaining small quantity of water in a plastic tank will not damage
tank by freezing.
2. Ensure all water has been drained from the hand pump by using an up and down
motion. No anti-freeze is needed for hand pumps.
3. Pour one pint of non-toxic anti-freeze into trap to ensure that the small amount of
water left in trap assembly does not freeze.
4. Faucets should be left in the open position to allow air movement until dry.

DEMAND OR POWER PLUMBING SYSTEMS

1. Drain all tanks and fresh water lines by opening tank drain valve V
Tank drain is outside left front corner of camper. Also open all faucet valves for air
to replace water space. Lines may not drain completely if faucets are not open.
2. Close valve V
& V
3
3. Close Valve V
to prevent anti-freeze from entering the tank.
1
4. Open valve V
and insert siphon hose into container full of non-toxic RV anti-
2
freeze.
5. Start demand pump to circulate anti-freeze throughout system.
and . . .
4
3 0
& V
(Fig. 4-4).
3
4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents