Replacing Switch And/Or Head Tube - Hobart 210 MVP Owner's Manual

7-6. Replacing Switch And/Or Head Tube

1
Remove screws (5)
and nuts (4).
Remove screw on
opposite side.
6 Hand-tighten head tube into cable connector.
8
Remove from vice. Reposition handle halves, and
install switch housing.
Tools Needed:
phillips
.
A complete Parts List is available at www.HobartWelders.com
! Turn Off welding power source
/wire feeder and disconnect gun.
4 Secure head
tube in vice.
5 Loosen jam nut.
Remove from vice
and turn head tube
out by hand.
15 mm
2 Remove handle halves.
Remove switch housing. Install new
switch and connect leads (polarity is
3
not important).
reverse order. If replacing head tube,
continue to end of figure.
7 Place head tube in vice and tighten until
nuts are tight.
9
Reinstall screws
and nuts.
Reinstall screw on
opposite side.
Reassemble in
243 840-A
OM-260 274 Page 29