Pro-Form XP 185 U User Manual page 10

10. Orient the Seat (12) and the Seat Carriage (29)
as shown. Attach the Seat to the Seat Carriage
with four M8 Nylon Locknuts (37) and four M8
Split Washers (36).
Loosen the Seat Knob (11) and slide the Seat
Carriage (29) onto the Seat Post (5) until it
stops. Next, attach an M6 x 8mm Button Screw
(56) to the Seat Post (5). Then, adjust the Seat
Carriage to the desired position and tighten the
Seat Knob.
10
12
37
11
11. Identify the Right Pedal (26), which is marked
with an "R." Using an adjustable wrench, firmly
tighten the Right Pedal clockwise into the right
arm of the Crank (13). Tighten the Left Pedal
(not shown) counterclockwise into the left arm
of the Crank. IMPORTANT: Tighten both
Pedals as firmly as possible. After using the
exercise cycle for one week, retighten the
Pedals. For best performance, keep the
Pedals tightened.
Adjust the strap on the Right Pedal (26) to the
desired position, and press the end of the strap
onto the tab on the side of the Right Pedal.
Adjust the strap on the Left Pedal (not shown)
in the same way.
26
Tab
12. Make sure that all parts are properly tightened before you use the exercise cycle, Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
10