Yaesu FTM-100DR Instruction Manual page 75

6
Turn the DIAL, select [2 LOW SPEED], and press
.
Move the cursor over the item for which you would
like to enter numbers.
When the speed drops below the set speed, the beacon is transmitted at the time
interval set under "4 SLOW RATE".
7
Turn the DIAL and set the far left digit.
You can set the speed to between 2 and 30.
Tips • To change the unit of distance, go to [10 APRS] → [11
APRS UNITS].
• Factory shipping value: 5
8
Press [
The cursor will shift to the right.
Tip Press
Press
9
Turn the DIAL and set thenext digit.
10
Press .
11
Turn the DIAL, select [3 HIGH SPEED], and press
.
Move the cursor over the item for which you would
like to enter numbers.
When the speed exceeds the speed set, the beacon is sent at a time interval that
has been set under "FAST RATE".
12
Refer to steps 7 - 9 to set the speed, then press
.
You can set the speed to between 3 and 90.
Tips • To change the unit of distance, go to [10 APRS] → [11
APRS UNITS].
• Factory shipping value: 70
13
Turn the DIAL, select [4 SLOW RATE], and press
.
Move the cursor over the item for which you would
like to enter numbers.
Set the beacon transmission time interval for when the speed drops below the speed
set under "2 LOW SPEED".
14
Refer to steps7 - 9 to set the time, then press
A time between 1 min and 100 min can be set.
Tip Factory default value: 30 min
].
[ ] → The cursor will shift to the left.
[ ] → The cursor will shift to the right.
Using the APRS set-up menu
.
74