Panasonic WV-NM100 Operating Instructions Manual page 26

BROWSING PICTURES
How to operate
If the preparations have been completed, you can begin the operation from the "Basic setup" page.
Screenshot 1
Begin the operation from the "Basic setup" page.
Screenshot 2
The "Control" page appears and the still picture of the cam-
era is displayed. Operation buttons are displayed below the
motion picture.
Note
• If the preparations have been completed, start up the
browser and display the "Top Menu" page of the desired
camera. The camera picture appears on the "Top Menu"
page.
• Several pictures shot during the panning/tilting may not
be displayed when "Refresh interval" is set to "Very
Slow".
26
STEP1
Click the [Control] button.
STEP2
Operate the camera and adjust the picture.
Panning and tilting
Click the arrow buttons (up / down / right / left)
to adjust the horizontal and vertical position.
The centre of the box surrounded by the arrow
buttons (the point where the horizontal line and
the vertical line cross) is the current position of
the camera.
If you click inside the box surrounded by the
arrow buttons, you can pan and tilt the camera
wider than by clicking the arrow buttons.
Image capture size
Click one of the picture resolution buttons (VGA
(640 x 480) / QVGA (320 x 240) / QQVGA (160
x 120)) to display the picture with the desired
resolution.
Adjustment of the brightness of the picture
Click the buttons to adjust the brightness of the
picture. The left end button (-) is the darkest and
the right end button (+) is the brightest.
Image size
Click one of the buttons (x1.0 / x1.5 / x2.0) to
select the desired image size.
When the picture is magnified, the quality of the
picture may be decreased.
AUX
Click one of the buttons (High/Low) to set the
status of the AUX output connector. (Refer to
"Alarm Connector and AUX Output Connector"
of WV-NM100 Operating Instructions in the sup-
plied CD-ROM for details.)
One time pan
You can monitor the picture by panning the
camera one time to the left and right.