Panasonic WV-NM100 Operating Instructions Manual page 22

SETUP SETUP
< Settings for Connection type 4 >
Item Description of the parameter
IP address If the broadband router uses the DHCP: No setting required
If the broadband router does not use the DHCP: Assignment of a private IP address is required.
However, the IP addresses already assigned to the PC and other cameras are not available.
For further information, refer to the operating instructions of the broadband router.
Netmask If the broadband router uses the DHCP: No setting required
If the broadband router does not use the DHCP: Setting of the subnet mask is required.
For further information, refer to the operating instructions of the broadband router.
Default gateway If the broadband router uses the DHCP: No setting required
If the broadband router does not use the DHCP: Assignment of an IP address to the router is
required.
For further information, refer to the operating instructions of the broadband router.
Network speed Set the network speed.
Use the default setting "Auto" for the network speed.
Selectable parameters: Auto (default setting), 100 Mbps (full duplex), 100 Mbps (half duplex),
10 Mbps (full duplex), 10 Mbps (half duplex)
HTTP port If multiple cameras are connected, it is required to set up each camera individually.
However, the port numbers already assigned to other hardware are not available. The following
port
Port number: 20, 21, 23, 25, 42, 67, 68, 69, 105, 110, 123, 161, 162, 546, 547, 5002
Host name Refer to your Internet service provider and set the designated host name if required.
BOOTP No setting required
DHCP Set to ON if the broadband router uses the DHCP.
DNS Set to ON when using the DNS.
Primary server Set the IP address of the DNS server when using the DNS.
Refer to your Internet service provider for the IP address of the DNS server. Primary and sec-
ondary IP addresses can be set for the DNS.
If the camera is accessed via the Internet, assign the global IP address to the broadband router, and set the
address translation function to use. (Refer to page 23.)
22
numbers are also not available because this camera already uses them.