Panasonic WV-NM100 Operating Instructions Manual page 14

SETUP SETUP
Screenshot 3
The setup window appears.
14
STEP4
Set parameters for each item.
"IP Address"
"Subnet Mask"
"Default Gateway"
"HTTP Port"
Enter parameters depending on your environ-
ment.
For further information about the parameters,
refer to pages 16, 18, 20 or 22.
"DHCP"
"DNS"
Click the [Enable] radio button when using the
DHCP and the DNS.
When using the DNS function, enter the
"Primary DNS Server address" and the
"Secondary DNS Server address".
Notes
• If DHCP is enabled although there is no
DHCP server in the network, check [Disable]
for DHCP in the "Panasonic IP Setup" win-
dow.
• If DHCP is enabled, and the DHCP server
has not assigned an IP address yet,
"0.0.0.0" is displayed for the IP address. The
IP address of the camera will be displayed
after the DHCP server assigns one to the
camera.
STEP5
Click the [SET] button after completing the set-
ting.
! Important
It takes around 20 seconds to complete the
settings of the camera after the [SET] button
is pressed. If the AC adapter or the Ethernet
cable is detached before the settings are com-
pleted, the settings may not be performed cor-
rectly.