Panasonic WV-NM100 Operating Instructions Manual page 18

SETUP SETUP
< Settings for Connection type 2 >
Item Description of the parameter
IP address Set the IP address designated by your network administrator.
However, the setting is not required if the DHCP is used in an intranet.
Netmask Set the subnet mask designated by your network administrator.
However, the setting is not required if the DHCP is used in an intranet.
Default gateway Set the IP address of the default gateway designated by your network administrator.
However, the setting is not required if the DHCP is used in an intranet.
Network speed Set the network speed.
Use the default setting "Auto" for the network speed.
Selectable parameters: Auto (default setting), 100 Mbps (full duplex), 100 Mbps (half duplex),
10 Mbps (full duplex), 10 Mbps (half duplex)
HTTP port Use the default setting "80" for the HTTP port.
Host name Refer to your network administrator and set the designated host name if required.
BOOTP Set to ON when using the "Panasonic IP Setup" software
DHCP Set to ON if the intranet uses the DHCP.
DNS Set to ON when using the DNS.
Primary server Set the IP address of the DNS server when using the DNS.
Secondary server Refer to your Internet service provider for the IP address of the DNS server. Primary and sec-
ondary IP addresses can be set for the DNS.
18