Switching To Continuous Forms; Tips On Paper Handling; General Tips; Multipart Forms - Fujitsu DL3700 Pro User Manual

PAPER HANDLING

TIPS ON PAPER HANDLING

3 - 2 6
#03 Chapter 3

Switching to Continuous Forms

To switch from single sheets to continuous forms:
1. If a sheet of paper is loaded, remove the paper by turning the
platen knob or pressing and holding down the LF/FF button.
CAUTION
Failure to remove paper may cause a paper jam.
2. Move the paper select lever to the rear to the continuous forms
position.
3. Press the LOAD button. The continuous forms paper advances
to the top-of-form position.
You are now ready to print using continuous forms paper.

General Tips

• Use high-quality paper. Do not use paper that is wrinkled or
curled at the edges.
• Do not use paper with staples or metal parts.
• Do not use paper with unpredictable variations in thickness,
such as paper with partial multilayers, paper with embossed
printing, and labels with the backing sheet exposed.
• Store paper in a clean, dry environment.

Multipart Forms

• Avoid using carbon-interleaved single sheets if possible.
Printing tends to become misaligned on the bottom sheet.
• To ensure smoother feeding of paper-stapled, multipart forms,
raise the cut sheet stand to support the forms.
26
User's Manual
21.08.1998, 23:48 Uhr