Fujitsu DL3700 Pro User Manual page 127

User's Manual
#05 Chapter 5
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Items Options
<TEARPOS>
The following <TEAR-EN> item is printed when TEAROFF:AUTO
is specified for the <TEAROFF> item.
<TEAR-EN>
39
Description
Tearoff position.
VISIBLE Select this option when your
software positions forms to the
next top-of-form after printing the
last data. The printer performs
tearoff feed without adding a form
feed when data transfer has
stopped.
ALWAYS Select this option when your soft-
ware stops after printing the last
data. The printer performs tearoff
feed after adding a form feed when
data transfer has stopped.
Note: For both settings, tearoff
positioning will fail if the page
length setting does not match the
actual perforation spacing.
Tearoff enabled time (offset time).
0 SEC The offset time is from when data
1 SEC transfer stops to when the printer
2 SEC performs automatic tearoff feed.
4 SEC If the printer receives data again
6 SEC within the offset time, the printer
does not perform automatic tearoff
feed.
11.08.1998, 23:03 Uhr
USING SETUP MODE
5 - 3 9