Fujitsu DL3700 Pro User Manual page 53

User's Manual
#03 Chapter 3
Table 3.1 Levers and Buttons Used for Paper Handling
Lever/Button
LF/FF
TEAR OFF
LOAD
Paper
select
lever *
Paper
thickness
lever
* The following graphics are engraved on the cover.
3
Purpose
Form feed Press and hold LF/FF to execute a form
feed. Continuous forms are fed forward
by one page. Single sheets are ejected.
Line feed Press LF/FF within three seconds to feed
paper forward by one line.
Forward micro Press LF/FF and ONLINE to feed paper
feed forward by 1/180 inch.
Advance forms Press TEAR OFF to advance the forms
for tear-off perforation to the tear-off edge. Tear off
the forms, then press any button to
retract remaining the forms.
Reverse micro Press TEAR OFF and ONLINE to feed
feed paper backward by 1/180 inch.
Load/unload Press LOAD to load paper or to retract
paper continuous forms to the "park position."
Save adjusted Press LOAD and ONLINE to perma-
load point nently store the load position adjusted by
micro feeding.
Select paper Move the paper select lever forward for
path single sheets (cut sheet stand or feeder).
Move the paper select lever backward for
continuous forms.
Adjust for Select the number corresponding to the
paper thickness number of copies (including the original).
or number of Vary the setting up or down (including A
copies to D) to optimize printing. Select D when
replacing ribbon or clearing a paper jam.
: Continuous forms
: Cut sheets
21.08.1998, 23:48 Uhr
PAPER HANDLING
Action
3 - 3