Fujitsu DL3700 Pro User Manual page 157

User's Manual
#07 Chapter 7
Table 7.1 Print Quality Problems and Solutions (Cont.)
Problem
Printing is
vertically
misaligned
(jagged).
The top margin is The top margin is the sum of the top-of-form
wrong.
Lines are double
spaced instead of
single spaced.
The printer
overprints on the
same line.
The next print line Change the LF-CODE setting in the printer
starts where the
previous line
ended instead of
at the left margin.
3
TROUBLE-SHOOTING
Solution
Use the printer's V-ALMNT function to
check the vertical print alignment. If necessary,
adjust the print alignment. See the section
Using the Diagnostic Functions in Chapter 5.
setting, the software-specified top margin, and
the printer's TOP-MRG setting. Proceed as
follows:
• Make sure that the top-of-form setting is
correct. The factory default is 25.4 mm (1
inch). See the section Changing Top-of
Form in Chapter 5.
• Check the software-specified top margin.
Refer to your software documentation.
• Check the printer's TOP-MRG setting. See
the section Changing MENU1 and MENU2
Options in Chapter 5.
Check the line spacing setting in your software.
Change the CR-CODE setting in the printer
setup mode to CR ONLY. See the section
Changing MENU1 and MENU2 Options in
Chapter 5.
Change the CR-CODE setting in the printer
setup mode to CR & LF. See the section
Changing MENU1 and MENU2 Options in
Chapter 5.
setup mode to LF & CR. See the section
Changing MENU1 and MENU2 Options in
Chapter 5.
11.08.1998, 23:03 Uhr
7 - 3