Inside Sill, Rear
Installation
NOTE:
Welding symbols
●
: 2-Plate spot welding
: 3-Plate spot welding
: 4-Plate spot welding
: MAG plug welding
: MAG welding
L=Welding length unit: mm (in)
( ): The number of welds
●
1. Separate new inside sill B and inside sill A. Remove
the middle floor outrigger (C), the floor frame
outrigger (D), the trailing arm outrigger (E), and the
quarter pillar stiffener extension (F) from new inside
sill B.
A
B
2. Insert inside sill B into the inside sill stiffener (A) under
the floor panel (C) halfway, and apply the sealer (D) on
the center pillar lower extension (E) at the inside sill
separator locations.
Sealer thickness: 10mm (0.39in)
A
B
E
3-36
C
D
F
C
D
B
D
3. While inserting inside sill B into inside sill A, push the
tip of inside sill B to the side sill reinforcement side
(C), and align inside sill B in inside sill A.
E
4. Install the front seat rear bracket mounting bolts (A),
and clamp inside sill B.
5. Clamp the new quarter pillar stiffener extension and
the rear wheel arch extension.
6. Check the body dimensions.
Sliding door rail lower support positions (see page
●
4-10)
Front floor and rear floor, under view (see page
●
4-18)
Inside sill positions (see page 4-19)
●
Repair chart, top view (see page 4-20)
●
Repair chart, side view (see page 4-22)
●
B
C
A
A
8 x 1.25 mm
22 N·m (2.2 kgf·m, 16 lbf·ft)
B