NETGEAR DGN3500 User Manual page 79

N300 Wireless Gigabit ADSL2+ Mode m Router DGN3500 User Manual
2. In the main menu, under Advanced, select Static Routes to display the Static Routes table.
Figure 40.
3.
To add a static route:
a. Click Add to open the following Static Routes screen.
Figure 41.
b. Enter a route name for this static route in the Route Name field. This name is for
identification purpose only.
c. Select Private if you want to limit access to the LAN only. The static route will not be
reported in RIP.
d. Select Active to make this route effective.
e. Enter the destination IP address of the final destination.
f. Enter the IP subnet mask for this destination. If the destination is a single host, type
255.255.255.255.
g. Enter the gateway IP address, which must be a router on the same LAN segment as
the router.
h. Enter a number between 2 and 15 as the metric value in the Metric field. This
represents the number of routers between your network and the destination. Usually,
a setting of 2 or 3 works.
4. Click Apply. The Static Routes table is updated to show the new entry.
Chapter 5: Advanced Configuration | 79