Environment Settings; Machine Settings; Centreware Internet Services Settings - Fuji Xerox ApeosPort-V C3320 DocuPrint CM415 AP User Manual

Environment Settings

Environment Settings
This section explains how to set the environment for using AirPrint.

Machine Settings

This section describes several points that need to be set by system administrator. Check the
proper settings below from [Tools] before you enable AirPrint.
Port Settings
Set [System Settings] > [Connectivity & Network Setup] > [Port Settings] > [Bonjour] >
[Bonjour Port Status] to [Enabled]*.
Set [System Settings] > [Connectivity & Network Setup] > [Port Settings] > [IPP] > [IPP
Port Status] to [Enabled]*.
* [Enabled] is selected by factory default.
Protocol Settings
Set IP address, subnet mask, and gateway address from [System Settings] >
[Connectivity & Network Setup] > [Protocol Settings] to use the machine in TCP/IP
environment.
Security Settings
Set server certificate verification or port number from [System Settings] > [Connectivity
& Network Setup] > [Security Settings] to communicate in SSL with the machine.
Note

CentreWare Internet Services Settings

AirPrint Setting
AirPrint setting is required when your machine uses AirPrint.
1
Start a web browser from a network connected computer.
2
Enter the machine's IP address into the address box on the browser, and then press the
<Enter> key. Connection to CentreWare Internet Services is established.
Note
3
Select the [Properties] tab > [Connectivity] > [Protocols] > [AirPrint].
4
Configure the following settings and click [Apply].
General
4
• Set these items if communicating in SSL.
• During connection/operation, pop-up screen for user ID/passcode entry may appear. In this case,
enter a system administrator's user ID/passcode and click [OK].
Items
AirPrint
Contents
Check the checkbox to enable AirPrint.
Note • The checkbox is checked by factory
default.