Replacing A Wheel - Ferrari 2012 F12 Berlinetta Owner's Manual

Replacing a wheel

Important note
If one or more wheels need to be replaced, proceed as follows:
• replace the wheel stud bolts with damaged threads or tapers
• carefully clean the wheel stud bolts before fitting
• do not lubricate the contact surfaces between the stud bolt
and the wheel rim and between the wheel rim and the brake
disk.
In order not to remove the antilock coating, do not clean the
wheel rim cones with solvents or aggressive products.
Collapsible space saver spare wheel (optional)
On request, the vehicle comes with a kit containing:
• collapsible spare wheel A with space-saving tyre; label
the maximum speed allowed of 80 km/h (50 mph);
A B
• additional tool bag
and the socket wrenches for operating the jack and tightening the
wheel stud bolts.
Warning
The space saver spare wheel must only be used for short trips in
the event of an emergency.
When the spare wheel is fitted, never exceed the maximum
speed of 80 km/h (50 mph) and drive carefully, especially
around bends and when overtaking, avoiding sudden
acceleration or braking.
Do not exceed the approved weight limits.
Do not fit snow chains on the spare wheel.
Never fit more than one spare wheel at a time.
Important note
B indicates
Failure to comply with these instructions could lead to loss of
control of the vehicle and consequently damage to the vehicle
and injuries to its occupants.
C
Advice for Emergency Situations
C containing the jack for raising the vehicle
4
215