Starting And Driving The Vehicle; System Start-Up - Ferrari 2012 F12 Berlinetta Owner's Manual

Starting and driving the vehicle

System start-up

After turning the ignition key to position II (key-on), both TFT
displays are activated on the instrument panel and system diagnosis
is performed. During diagnosis, which lasts 5 seconds, a check is
performed on the warning lights on the panel and the presence of
any faults is checked.
If diagnosis detects any errors, they are only displayed once the
5 seconds required for the check have elapsed. The cases listed
below are an exception and errors are displayed as soon as the key
is turned to on, even during diagnosis:
- Low engine oil pressure (see page 110)
- Inertia switch triggered (see page 109)
- Semi-automatic gearbox safety warnings
- Deactivation of EPB warning (see page 162).
If the next scheduled maintenance deadline is approaching, each
time the key is turned to on, information on scheduled maintenance
is automatically displayed after diagnosis. For further information,
refer to the "Maintenance Schedule" paragraph on page 234.
Finally, each time the key is turned to on, the message for activation
of the alarm when an intrusion has been attempted (see page 19) is
also displayed (after diagnosis).
Once the system check has been completed, the gearbox display
is activated and the letter "P" (Parking) or "N" (Neutral) will be
displayed.
Important note
BEFORE YOU DRIVE
If the warning light does not turn off after diagnosis,
A
indicating a fault in the gearbox also shown by the symbol and
special message on the left TFT display (see page 114), contact
the Ferrari Service Network.
A
About your Vehicle
3
145