Replacing remote control batteries
If you press one of the three buttons on the key and this does not
activate the corresponding function, check that the alarm system
functions are operating correctly by using the other remote control
before replacing the two remote control batteries.
Replace the remote control batteries as follows:
- open the key cover
using a small screwdriver at the position
C
indicated by the arrow;
- remove the two batteries E, pushing in the direction indicated by
the arrow to release them from the retainer cover D;
- fit two new batteries of the same type, observing the indicated
polarity;
- close the key cover C.
Important note
Do not use sharp tools to remove the cover and be careful to
avoid damaging the remote control.
C
Electronic alarm
The electronic alarm system performs the following functions:
- remote control for central door locking/unlocking;
- perimeter surveillance, detecting if doors and lids are open;
- motion surveillance, detecting intrusion in the passenger
compartment;
- vehicle movement surveillance (anti-lift).
Activation
To turn on the alarm system, press button
- the turn indicators flash once;
- the system "beeps";
- the red LED on the dashboard flashes;
- the central door locking system is activated and the doors are
locked.
The system activates after approximately 25 seconds.
E
D
F
F
G
1
on the ignition key:
General
17