Smart Card Reader - HP zbook 15 G3 Maintenance And Service Manual

Smart card reader

Description
Smart card reader (includes cable)
The smart card reader bracket is available in the Bracket Kit, spare part number 848232-001.
Before removing the smart card reader, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery (see
Remove the smart card reader:
1. Release the ZIF connector (1) to which the smart card reader cable is attached, and then disconnect the
smart card reader cable from the system board.
2. Loosen the four captive Phillips screws (2) that secure the smart card reader to the base enclosure.
3. Remove the smart card reader (3).
Reverse this procedure to install the smart card reader and cable.
Bottom cover on page
Battery on page 31).
29).
Component replacement procedures
Spare part number
848245-001
53