Led Board - HP zbook 15 G3 Maintenance And Service Manual

LED board

Description
LED board
Before removing the LED board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery (see
Remove the LED board:
1. Disconnect the LED board from the system board (1).
2. Lift to release the LED board cable from the adhesive that secures it to the computer (2).
3. Remove the Phillips PM2.5×3.0 screw (3) that secures the LED board to the computer.
4. Remove the LED board and cable from the computer (4).
5. Remove the LED board
Reverse this procedure to install the LED board.
50 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page 31).
29).
Spare part number
848246-001